Marathon Sprint Series Instrucciones de operaciones descargar pdf (Pagina 15)

Installation duo

Caution!

Mount the drive in parallel to the runner rails of the door.

• Align ceiling bracket (1). It should be located within a range of

B = 0 ... 600 mm.

• Align drive mechanism horizontally to rear centre of door (HM). Mark

position of holes. Drill two holes (Ø 10 x 65 mm deep).

Wear safety goggles when drilling!

Check thickness of ceiling, particularly with prefabricated

garages!

• Insert plug (1). Fit two screws (2) with plain washers (3). Tighten

screws (2) securely.

• Align C-rail (4) at correct height. If necessary, move screws (5).

Tighten screws (5).

• Mount drive shaft (1):

Insert the long bolt (2) and slide on the securing clip (3).

• Attach the door hinge (4) to the connecting rod (1) using the short

bolt (5) and slide on the securing clip (3).

• Pull once on emergency release wire (N), thus disengaging bogie

unit (1). Tighten screw (8) on lintel fitting.

• Use drive shaft (2) to push bogie unit (1) as far forward as possible

(3). If necessary, release cut-off buffer (4).

• Align angle of door fitting (5) with centre of door (VM) and mark

5 drill holes. Drill 5 holes (Ø 5 mm).

Use screws that are appropriate to the door material.

Wear safety goggles when drilling!

• Insert 5 hexagon-head screws (6) and tighten securely.

• Release cut-off buffer (4) and push right up to bogie unit (7).

• Tighten cut-off buffer screw (4) securely.

• Release rear cut-off buffer (1) and push right back to stop (2).

Open door (3) by hand.

max. 30°

4 8

Trim (e.g. saw off and debur) projecting part of ceiling bracket

(4).

• Push cut-off buffer (1) right up to end stop (6) against bogie unit (5),

until it clicks. Securely tighten screw on switch-trigger (1).

Installing and connecting the control

unit

Selection of the installation option

Position the push-button in such a way that the operator can see

the door, while he/she is not inside the operating area of the

door.

Install cable in such a way that it is possible to expand the power

supply in option A (if the cable is at right angles to the C-rail,

install it with a loop).

Touch the control unit (3) only at its edge!

Do not touch the electronic components!

• Loosen the screw (1) and remove the lamp hood (2). Dismantle the

control unit (3).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Comentarios a estos manuales

Sin comentarios

Marathon Sprint Series Instrucciones de operaciones Pagina 15

Comentarios a estos manuales